9
14. Attach the two 10-pound Short Caps (20) to the
10-pound Center Resistance Bar (44) with two
M4 x 12mm Flat Head Screws (85).
Using twelve M4 x 12mm Flat Head Screws (85),
attach the two 10-pound Caps (101) to the 10-
pound Removable Resistance Bar (67), the two
20-pound Caps (88) to the 20-pound Removable
Resistance Bar (36), four 80-pound Caps (100) to
the two 80-pound Resistance Bars (95), the two
40-pound Caps (79) to the 40-pound Resistance
Bar (96), and the other two 80-pound Caps (100)
to the 80-pound Top Resistance Bar (105).
13. Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four 1/4” x 45mm Button Screws (58).
Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12).
Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
13
15
8
58
14
12. Attach a Plastic Foot (53) to the Backrest Frame
(15) with an M4 x 16mm Screw (62).
Attach the two Guard Plates (17) to the inside of
the Backrest Frame (15) with four M4 x 16mm
Screws (62).
12
53
62
15
17
62
62
17
15. Orient the Cover Plate (72), with the edges up.
Attach the 80-pound Top Resistance Bar (105) to
the Cover Plate with the two 1/4” x 25mm Screws
(108).
Note: The Top Resistance Bar must be
closer to the back of the Cover Plate.
15
79
88
101
20
100
100
105
108
72
67
36
95
96
105
85
85
85
85
85
44
15
12
Rod
Slot
14
Edges
up
Back
