Wegener UNITY4000, Инструкция по эксплуатации

Страница: 61 / 75

B-11 UTY4000-003
B1.3.5 NC Status
N C S T A T U S
P r e s s S e l e c t
The following screen shown only if applicable (value non-zero):
D E L A Y I N G : h h : m m : s s
Delay time to execution of COMPEL command where hh:mm:ss is hours, minutes, seconds.
S / N : s s s s s s x x x x x x x x
C O M P E L : y y y y y y y y y y
Where ss...ss is unit serial number, xx...xx is COMPEL lock status (LOCKED or UNLOCKED),
and yy...yy is COMPEL required status (REQUIRED or NOT REQUIRED).
L O C A L C T R L : x x x x x x x
N E T W R K M O D E : y y y y y
Where xx...xx is local control enable status (ENABLED or DISABLED), and yy...yy is network
protection mode (PROTECTED or SHARED).
L A S T H D R : h h h : m m : s s
L A S T A D R : h h h : m m : s s
Where hhh:mm:ss is the elapsed time in hours, minutes, seconds. LAST HDR is the time since
the last COMPEL packet with a valid network header was received, and LAST ADR is the time
since the last COMPEL packet with valid header was addressed to this particular IRD.
H I S T O R Y : h h h : m m : s s
T O T L P R O C E S S D : x x x x x x
Where hhh:mm:ss is the elapsed time in hours, minutes, seconds. HISTORY is the time since
reset (usually power-up). TOTL PROCESSD: xx...xx is the total number of COMPEL packets
seen (including keep-alives) in that period.
The following 3 screens are shown only if applicable (valud non-zero):
I N V A L I D H E A D R : x x x x x
I N V A L I D C K S U M : y y y y y
Where xx...xx is the total number of invalid COMPEL headers received since reset; and yy...yy
is the total number of packets received (and rejected) with bad checksums.