9
3.
Install anchoring stands:
a)
Position the anchoring stands under the anchoring crossbar. Always position the
Chainless Anchoring Stands so that the bolt adjustment is correct to
counteract for any uneven floor conditions as described on Page 5.
NOTE: If your floor jack does not raise the vehicle high enough to allow the anchoring stand
under the end of the anchoring crossbar, then hang the stands on the ends of the
anchoring crossbar (as shown at the left) by the hole in the stand. Lower the vehicle
and raise again by jacking under the center of the anchoring crossbar. The anchoring
stand can then be placed under the anchoring crossbar and the vehicle lowered onto
the top of the stand.
b)
Insert the rail locks into the anchoring rails and into the short slots in the base
of the anchoring stands to align stands with the anchoring rails. Do not insert the
rail spacer wedges beneath the anchoring stand yet.
