Weco WF-103, Инструкция по эксплуатации, Страница: 21 / 32

WF-103
Cod.006.0001.1040
10/07/2017 v2.12
ENGLISH
0
21/32
12 JOBS MANAGEMENT
Personalised welding settings, or JOBs, can be saved in memory locations and subsequently uploaded.
Up to 99 jobs can be saved (j01-j99).
You can save the following settings in the JOBS:

the setting of the wire speed / amperes / thickness;

the correction of the arc (Volts);

the number of the program;

the torch button procedure (2T, 4T, 4T-3L);

the pre-gas value;

the post-gas value;

the burn-back value;

the soft-start value;

the motor slope value;

the hot-start value (only if in 4T-3L);

the crater-filler value (only if in 4T-3L);
The settings of the SETUP menu are not saved.
12.1 SAVING A JOB
This function is available when welding mode is not active.
S4 Hold down the button for 3 seconds.
SA. J.xx The message appears on the following displays: D1-D2
xx=
number of the first free job.
E2 Select the position in which to save the job with the encoder.
On selecting a currently occupied memory location, the job number flashes.
If you confirm at this point, the new job will overwrite the previously saved settings.
Exit without confirmation
Press any button (except S4).
This action will automatically close the menu.
Exit with confirmation
S4 Press the button.
This action will automatically close the menu.
12.2 LOADING A USER JOB OF FACTORY SET JOB
This function is available when welding mode is not active.
S4 Press and release the button.
LO. J.xx Only when the jobs have been uploaded, the message is shown on the following displays: D1-D2
xx=
number of the latest job used.
nO Job If there are no jobs in the memory the message is shown on the following displays: D1-D2
E2 Use the encoder to select the number of the job to be uploaded.
Exit without confirmation
Press any button (except S4).
This action will automatically close the menu.
Exit with confirmation
S4 Press the button.
J.xx The number of the loaded job remains shown on display D2.
xx= number of loaded job.
This action will automatically close the menu.