Weco WF-103, Инструкция по эксплуатации, Страница: 12 / 32

Cod.006.0001.1040
10/07/2017 v2.12
ENGLISH
WF-103
12/32
6 UNIT POWER-UP
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SEt GEn The message appears on the following displays: D1-D2
The message appears only when the wire feeder is not selected as the remote control on the power source.
6.1 POWER SOURCE MANAGEMENT BY REMOTE CONTROL
Hold down the button for 3 seconds.
OPERATION TO BE PERFORMED ON THE POWER
SOURCE USER INTERFACE
The following LED illuminates on the power source panel:
The following message appears on the power source displays:
- - -
The power source is managed by the remote control connected to it.
The welding power source sets up for welding.
First power-up or power-ups following a RESET procedure
The welding power source sets up for welding with the factory presets.
Subsequent power-ups
The welding power source sets up for welding in the latest stable welding configuration that was active at the time of power-off.
7 RESET (LOAD FACTORY SETTINGS)
The reset procedure involves complete restoration of the default values, parameters and memory settings set in the factory.
Too many changes made to the welding parameters so user finds it difficult to restore defaults.
Unidentified software problems that prevent the welding power source from functioning correctly.
7.1 TOTAL RESET
The reset procedure involves complete restoration of the default values, parameters and memory settings set in the factory.
All memory locations will be reset and hence all your personal welding settings will be lost!
Set the welding power source ON/OFF switch to “O” to switch the unit off.
S2 S6 Hold down both buttons simultaneously.
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
rEC FAC The message appears on the following displays: D1-D2