Page
5
of
17
DEPLOYMENT
Place the cutter over the wire rope. Ensure that the wire rope is as far into the cutter
as possible.
Pressurize the auxiliary cylinders to fully extend the anvil, thus retaining the material
in the body of the tool. Check visually that the anvil is fully home, this is important to prevent
damage to the tool.
Operate the main ram power port to sever the material, hold pressure until the material is
severed.
N.B
. Do not operate the auxiliary cylinders when the main ram is fully extended since this would
damage the anvil.
Please note that this tool has a relief valve fitted which will blow off at approx. 750 bar, DO NOT
leave the pressure on so that the relief valve is continually blowing off.
Once the material is severed, pressurize the main ram retract port to withdraw the cutting
blade. Then, and only then, retract the anvil. It is important not to operate the auxiliary
cylinders whilst the main ram and blade are in the fully extended position.
If a further cut is required, the above procedure should be repeated.
TROUBLESHOOTING
If the material does not cut through completely on the first attempt, cycle the blade by
retracting it slightly and then attempting the cut again.
If the material does not completely cut after multiple cycles of the blade, check the input
