Page
2
of
17
Description
The HCV155 is a double acting tool primarily intended for use on umbilical cable and hose and
will cut up to 155mm diameter. It may be used on alternative materials, such as electrical power
or communication cables, again up to a maximum of 155mm diameter. Where small diameters
are to be cut, every effort should be made to place the material centrally along the anvil to
minimize offset loading. The cutter is not designed to cut wire rope.
1.
SAFETY
Before operation, read and understand this operations manual.
Whilst the tool is intended for remote or local operation sub-sea, there is no reason why it
should not be used above surface.
Ensure that the tool, hoses and pump are in good condition and properly connected.
Ensure that suitable pressure regulation equipment is used and that the unit is not subjected to
pressures higher than those stated in section 3
In all cases, where an operator is present, the safety aspects must be reviewed before the
cutting operation is commenced.
No attempt should be made to cut any material that is under tension.
Ensure that the operator is shielded from the cutting blade during the cutting operation.
When cutting near the very end of hose or rope, individual cut wires can be expelled from the
tool, please ensure that the operator is shielded from these.
If in doubt please contact the manufacturer (Allspeeds Ltd) or an authorized distributor for
assistance.
If at any time it is necessary to carry out proof tests on the tool, e.g. after service on the
hydraulic cylinders, it must be returned to the supplier for testing where the following
procedures apply.
The maximum proof test pressure should not exceed 125% of the maximum working pressure
and this should only be done by Allspeeds using our specially adapted test rig.
The tool should be guarded during the proof test operation, and be carried out in
a safe working environment.
The proof pressure should be applied gradually, until the maximum pressure is reached.
