Weber Genesis 5000 LP, Руководство пользователя

Страница: 23 / 42

23
Figure 30
View from rear
of barbecue
Hinge rod
Figure 31
Figure 32
To lower table: Pull support rod up to disengage slide
lock and lower table. To raise table, lift table up and
engage slide in locked position. Figure 32.
F
Notch
Slide bar
Unlocked position
Slide
Support rod
Locked position
Wheel frame
View from front
of barbecue
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the
frame. Figure 30 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 30 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 30 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
WARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a
new part.
WARNING: The load limit for the swing table is
30 pounds.
(b)
(c)
(a)
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw,
insert screws through frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 31.