WWW.WEBER.COM
31
SEAR STATION
®
TROUBLESHOOTING
PROBLEM
CHECK
SOLUTION
Burners burn with a yellow or orange
flame, in conjunction with the smell
of gas (This is normal for the burner
lighting tube).
Sear Station
®
burner does not light.
Inspect Spider/Insect screens for possible obstructions . (Blockage
of holes .)
Clean Spider/Insect screens . Refer to “ANNUAL MAINTENANCE .”
Did you ignite the two adjacent main burners . Refer to “SEAR
STATION
®
IGNITION & USAGE” instructions for safe lighting
procedure .
Verify adjacent main burner ignition by visual inspection of a
flame .
m
WARNING: If ignition does not occur in five
seconds, turn burner control OFF, wait five
minutes to let the gas clear before you try
again.
Does burner light with a match?
If you can light burner with a match, then check the Crossover
®
Channel on the sear burner . Refer to “MAINTENANCE” for burner
removal and cleaning procedure .
Does the igniter work? (Do you see a spark when you repeatedly
use the snap igniter?)
Try manually lighting the burner . Refer to “SEAR STATION
®
IGNITION & USAGE .” Call Customer Service .
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com.
ROTISSERIE TROUBLESHOOTING
GRILL LIGHT TROUBLESHOOTING
PROBLEM
CHECK
SOLUTION
Rotisserie burner does not light.
Did you hold the burner control knob in and hold in for twenty
seconds until after burner ignited?
Try to relight burner by holding burner control knob in and
continue holding in until twenty seconds after burner has ignited .
Did you wait to see the entire ceramic surface become alight
before counting twenty seconds?
When relighting burner by holding burner control knob in, wait
to see the entire ceramic surface become alight before counting
twenty seconds?
Did you repeatedly use the snap ignition until the burner ignited?
After waiting five minutes for gas to clear, try repeatedly to use
the snap igniter until the burner ignites . Refer to “ROTISSERIE
BURNER IGNITION & USAGE .”
Does the igniter work? (Do you see a spark when you repeatedly
use the snap igniter?)
Try manually lighting the burner . Refer to “ROTISSERIE BURNER
MANUAL IGNITION .” Call Customer Service .
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com.
PROBLEMS
SOLUTIONS
Grill light does not turn on.
The grill light will activate only when lid is open . Lift the lid to the open position and press the AWAKE button .
Install new batteries . When installing new batteries (alkaline only), confirm that each battery’s plastic wrapping has
been removed . Verify that the batteries are in good condition and have been installed correctly . Refer to “MAINTAINING
THE GRILL LIGHT .”
Grill light turned off and will not turn back on.
The light is programmed to turn off automatically after 30 minutes of inactivity . To reactivate the light, make sure lid is
open and press the AWAKE button . Refer to “MAINTAINING THE GRILL LIGHT .”
Grill light does not turn off.
The grill light is equipped with a tilt sensor . The tilt sensor turns the light ON when barbecue lid is opened and OFF
when the barbecue lid is closed .
NOTE: The AWAKE button will not turn the grill light off . To turn the light off, put the lid in the closed position .
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com.
