WWW.WEBER.COM
21
SEAR STATION
®
IGNITION & USAGE
1
4
5
7
6
2
3
SEAR STATION
®
BURNER IGNITION
Summary lighting instructions are inside the left-hand cabinet door .
m
DANGER
Failure to open the lid while igniting the barbecue’s burners, or
not waiting five minutes to allow the gas to clear if the barbecue
does not light, may result in an explosive flare-up which can
cause serious bodily injury or death.
The Sear Station
®
burner has an on or off control setting . To ignite the Sear Station
®
burner you must first ignite the two adjacent main burners .
Adjacent Main Burner Snap Ignition
Note: Each main burner control knob snap igniter creates a spark from the igniter electrode
to the burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning to START/HI. This will ignite each individual burner.
A) Open the lid (1) .
B) Make sure all burner control knobs are turned off (2) . (Push control knob in and
turn clockwise to ensure that it is in the OFF position .)
C) Turn the LPG cylinder on by turning the cylinder valve anticlockwise (3) .
m
WARNING: Do not lean over the open barbecue.
D) Ignite each adjacent Sear Station
®
main burner (4) . Push the control knob in and
turn to START/HI until you hear the igniter snap, continue to hold control knob in
for two seconds . This action will spark the igniter, the burner lighting tube and then
main burner .
E) Check that the burner is lit by looking through the cooking grates (5) . You should
see a flame . If burner does not light on first try, push control knob in and turn to
OFF . Repeat lighting procedure a second time .
Sear Burner Lighting: Ignition By An Adjacent Ignited Main Burner
F) Turn Sear Station
®
burner control knob to the ON position (6) .
G) Verify burner ignition by visual inspection of a flame (7) .
m
WARNING: If ignition does not occur in five seconds, turn
burner control OFF, wait 5 minutes, and repeat steps F & G, or
see “SEAR STATION
®
MANUAL IGNITION” instructions.
m
WARNING: If the burner still does not light, turn the burner
control knob to OFF and wait five minutes to let the gas clear
before you try again or try to light with a match.
Note: See “MAINTENANCE” for burner removal and cleaning
procedure.
◆
TO EXTINGUISH
Push in and turn each burner control knob clockwise to OFF position . Turn gas supply
off at the source .
◆
The barbecues illustrated in this
Owner’s Guide may vary slightly
from the model purchased .
2
6
ARRÊTÉ
APAGADO
OFF
ON
