Weaver W-957-40, Руководство по эксплуатации

Страница: 25 / 42

25
loose
4. computer board fault
Display is normal
but the start button
and input push
button not
working.
1. contact switch not good
2. machine breakdown
1. Open the housing of the machine and
plug in and tight the contact switch plug.
2. Start the machine again
Display is normal
but not braking
after start.
1. The cable between the
power board and computer
loose 2.power board fault
2. Brake resistor damage
3. computer board fault
1. Plug in and tight the cable between the
computer board and power board.
2.Change the power board 3.Change the
computer board
Balance is not
accurate & difficult
to reach ―00‖
1. sensor lead connect or
contact no good
2. memory value lost
1. Connect again 2. Correct the memory
value according to the manual.
Each spin, the
change of the
value will not
exceed 5g
1. There are foreign body on
the rim or the assemble
surface in the rim center
deformation
2. sensor damp or quick nut
not tightly clamped
3. The external power
voltage or the air pressure not
enough. The flange dick not
locked.
1. Change the wheel
2. Oven, recalibrate the sensor.
3. Fix the anchor bolt.
Each spin, the
range of the
change of value
will be 20-90g.
1. There are foreign bodies
on the wheel or the unbalance
of the wheel value too big.
2. sensor damage
3. external power source
voltage too low
1. Change the wheel
2. Check the sensor and wiring.
3. Check power source and assemble
stabilizer.
Balance is not
accurate & difficult
to reach ―00‖
1. Sensor damp or damage
2. Program chore
1. Calibrate again,oven and then
self-calibration or change 2.Self-calibration
again
When second
mount & demount,
the error will
exceed 10g.
1. Wheel internal hole
irregular
2. Flange disk assemble not
properly
1. Change the wheel 2.Check the
assemble surface and try again.