W'eau EV60, Руководство пользователя, Страница: 17 / 102

ENGLISH
16
Problem Possible Cause Solution
Pool vacuum does not
capture debris / fine
particles
Battery is running out Charge the battery again.
Impeller is jammed
Power off the pool vacuum and visually check the gap in the middle of the
pool vacuum to see if the impeller is jammed by large debris. If possible,
use a small tool to remove the debris carefully. If necessary, contact your
dealer for further instructions.
WARNING!
Make sure the pool vacuum is powered off when
the unit is being serviced.
Impeller is broken Contact your dealer for impeller replacement.
Canister is full Empty the canister.
Filter cone is clogged by fine
particles Clean the filter net. If brushing is deemed necessary, use only a soft brush
to clean the filter cone gently and carefully.
Cartridge filter is full Follow cleaning instruction to clean the cartridge.
Debris escapes from the
canister
Suction nozzle flap is broken
Suction nozzle flap works like a door to prevent debris from escaping from
the canister. Replace a new nozzle flap.
Debris goes inside the
filter cone
Filter cone is damaged Replace with a new filter cone.
Fine debris escapes from
the cleaner
Cartridge filter is broken Replace a new cartridge filter.
Telescopic pole connector
/ curved handle cannot be
secured in assembly
Side pin on pole connector /
handle is broken
Replace with a new pole connector/handle.
Pool vacuum cannot be
charged / recharged
Battery is damaged
Contact dealer for battery replacement.
WARNING!
DO NOT open the pool vacuum and replace
the battery by yourself. This could result in severe or fatal injury and the
warranty will be voided as a result.
Charging plug is not correctly
connected to external
adaptor and pool vacuum
Refer to instruction manual and connect the charging accessories
correctly.
External adaptor damaged
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor will result in
damaging the pool vacuum / battery and voiding the warranty as a result.
Pool vacuum does not
move smoothly
Wheel is jammed Clean out the debris from the wheel.
Charging time is longer
than advertised
Stained charging pins
The stains can be removed by using a cotton bud soaked with juice of
lemon or vinegar to clean the areas around the charging pins.
Operation time is shorter
as expected
Battery is not fully charged
Charge the pool vacuum for at least 6 hrs. NOTE: if any stains are found on
the charging pins, remove them by using a cotton bud soaked with lemon
juice or vinegar.
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles
electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items containing removable
batteries, remove batteries before disposing of the product.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of Kokido
Development Ltd. (L-23011001)
TROUBLESHOOTING
If soft copy of this instruction manual is required, please contact our customer service by email:
customerservice@kokido.com
SAVE THESE INSTRUCTIONS