W'eau EV60, Руководство пользователя, Страница: 13 / 102

ENGLISH
12
• Clean the cartridge filter
Follow the instruction in “Cartridge filter setting” to detach cartridge filter.
Inspect everything for damage and wear. If you find any damages or tears, it’s time to replace the cartridge.
It is recommended to wash the cartridge filter with a water jet after each pool cleaning cycle. Spray at an angle to
get rid of the debris between the pleats of the cartridge filter. Never use a pressure washer as it will damage the
cartridges. If the cartridge is really dirty, soak it in water with detergent for 2-3 hours, then rinse it with a water jet.
If brushing is deemed necessary, use only a soft brush to clean it carefully and gently to avoid any damages.
MAINTENANCE & STORAGE
NOTE:
1) Be sure to clean and dry the areas around the charging port and charging pins after every use to avoid the
forming of stains (byproduct of a natural chemical reaction between electric current and water). Otherwise, the
stains can be removed by light scrubbing with a cotton bud soaked with juice of lemon or vinegar.
2) Battery discharges on its own during storage. Make sure to charge the pool vacuum to about 30% to 50% of the
battery capacity before it is stored.
3) You must re-charge the battery at least once every three months when it is not in use.
· Unplug the external adaptor from socket and then unplug the adapter jack from the charging plug.
· Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and accessories with fresh
water. DO NOT use detergent.
· Make sure to drain the water from the unit, handle and pole connector.
· Use a damp cloth to clean and dry the pool vacuum and its accessories.
· Store them in a well-ventilated area away from the sunlight, children, heat, ignition sources, and pool chemicals.
Ambient temperature for storage should be 10˚C – 25˚C (50˚F – 77˚F). NOTE: A higher temperature may reduce
the battery life during storage.
· To better organize the hose connector in
storage, screw the connector onto the
cartridge valve.
WARNING!
- Never attempt in any way to disassemble the pool vacuum.
- Under no circumstances should you attempt to disassemble the
pool vacuum and replace the impeller, motor and battery by
yourself.
CAUTION !
· Excessive heat can damage the battery and reduce its lifespan as a result.
· Consult your dealer regarding battery replacement if the following happens:
- Battery does not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times of the first few operations (on a
full charge). Use these run times as a reference point for comparison with run times in the future.
· The battery must be removed from the pool vacuum before it is scrapped.
· The pool vacuum must be disconnected from the supply mains when removing the battery
· The battery is to be disposed safely and according to local ordinances or regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a result.