6
ASSEMBLY
Step 2: Attaching legs
●
Repeat the same procedure on the opposite side. (fig. 8).
8
1
9
3
3
1
10
8
2
1
NOTE:
●
Do not let the roof rest on the legs until all three legs
on one side are completely installed and in place.
Step 3: Attaching bottom cross rails
●
Attach the bottom cross rails (6) to the legs and cover the joints with the
cross rail clamps (12, 13). Align all holes and insert the fittings (15, 16,
17) (fig. 9). Do not tighten fully at this stage.
9
3
6
17
16
15
6
12
13
●
Repeat the same procedure on the opposite side.
●
Adjust the bottom cross rails (6) so that they are of same height from the
ground.
.
Now tighten the fittings (15, 16, 17) (fig. 10).
10
6
6
6
6
Step 4: Squaring up frame
●
Be sure the frame is standing at the desired location.
●
Level the frame both end-to-end and side-to-side.
●
Check that the frame measures 8' (244 cm) in width (fig. 11).
●
Measure the distance between the interior of the frame feet diagonally.
The sections A to B and C to D should be of equal length (fig. 11). If they
are not of equal length, tap the corner leg of the longer section (using a
rubber mallet) inward until both diagonals are equal.
11
A
B
D
8
'
8
'
C
Step 5: Anchoring frame
CAUTION!
●
The shed must be well-anchored.
●
Do not attempt to install any of the fabric before the
frame is properly anchored.
●
If the ground is hard or rocky, pre-drill holes before
inserting the anchors.
●
Four anchors (21) are provided to secure the shed. They are to be
installed around the bent corner legs (3) at each corner of the shed.
●
Screw the anchor head into the ground.
●
Insert the cable (22) through the eyelets of the anchor (21) and the bent
corner leg (3). Secure the cable (22) with the cable clamp (23) (fig. 12).
●
Repeat the same procedure for the other three anchors (21).
12
21
3
23
22
