J
L
K
L
J
Only for PP Version
1) Loosen screws
J
(do not remove). To dismantle
the frame (for setting or adjusting of the optical
elements), always use the passage holes
L
.
When adjusting the projector the cover must
be firmly attached to the luminaire for safety
reasons. Carefully remove the frame of the pro-
jector
K
towards the front.
Only for PP Version
2) The retainer
N
with the desired insert always
remains in the position set at the factory, also the
retainer
O
(only available with CC / TW projec-
tors). Do not change this Position!
GP Version:
Holder
Y
with shield ID24.
The projector is factory set at 33 ft distance.
O
R
Q*
Y
T1
T2
T3
N
Only for PP Version
2.1)
Gobo projector – [GP]
Pull the gobo cassette out of the gobo holder.
Loosen screw
P
on the gobo cassette, unfold
the cassette and place gobo
M
(motif up to
max. ø 38 mm) in the lower part
M
. Then close
the cassette again and tighten screw
P
again.
Now push the cassette back into the gobo
holder. Gobo thicknesses up to 1.2 mm are
permitted.
N
X
Only for PP Version
2.2)
Frame projector – [FP]
The contour of the emitted light may be set with
the four shutters
X
by using the contour slide
in the retainer
N
. To do so, unscrew the thumb-
screws
W2
, set the desired contour by moving
the shutters
X
and tighten the fasteners
W2
.
Frame size in the projector max.: 30 mm;
min.: 11 mm
W2
X
P
M*
N
7) After setting the projector, slide the frame
K
back on and tighten the screws
J
.
