Wavion WBSn-2400, Руководство пользователя

Страница: 9 / 42

WBSn-2400 User Guide Page - 9 -
Connecting Antennas (for WBSn-2400-O only)
Note: The antennas should only be connected once the installation procedure has been successfully
completed.
How to connect the
antennas:
Screw each of the three antennas into the three N-type connectors on the
WBSn-2400 base station unit.
Warnings
In order for the WBSn-2400-O to work properly, all three antennas must be
connected.
Only connect the unit to the power supply once all the antennas are connected.
Use caution when connecting the antennas. Undue haste can damage the unit.
Do not screw in the antenna when holding its top section, or you may damage
the antenna.
Antenna Sealing
The following procedure describes how to correctly seal the antennas against moisture.
Caution
• It is important to carefully read this procedure and perform all the steps, to
ensure maximal moisture protection.
• Use high quality sealing material to ensure IP-68 compliant protection
against dust and water.
How to seal the
antennas:
1. After the antenna is connected, use the supplied isolation tape to cover the
N-Type connectors and the lower part of the antennas.
2. Cut 18 cm of the attached splicing tape.
3. Stretch and wrap the tape in an even, half overlapping manner around the
antenna and N-Type connector. Cover this with a layer of vinyl plastic tape.