5 of 11
WX-501-0534 • 01.22
The following settings are common to all four application drivers:
Setting
Description
Description
Shows a description of the device being configured. This is only for your information and does not
affect the operation of the device.
Location
Displays the location of the device being configured. This is only for your information and does not
affect the operation of the device.
Device ID
Gives the ID number of the device being configured, which is used to identify the device when you
are connecting to it. By default, this number is the last five digits of the serial number, which can be
found under the About tab or on the barcode sticker on the bottom of the device. It is recommended
that you do not change this number unless another device on your network has the same ID number.
RF Channel
Specifies the frequency channel of the device (the channels range from 0 to 47). Each client
and server must be on the same channel. It is recommended that each system be on a different
channel, since the ranges on these devices extend for miles and sharing the same channel with
another location could result in interference.
Tx Power (1W Max)
Allows you to modify the power level in increments of 10%. The Click 400 transmit power can be
reduced to decrease interference caused by multiple radios.
Baud Rate
Allows you to change the baud rate at which the device connects to the sensor.
Under the
About
tab, you can view information about your Click 400 (see the figure and table below).
The following settings are common to all four application drivers:
