Watts ZRO-PURE, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 24

Page 8
Water supply line to the system must be from the cold water supply line only. Hot water
connection is used for rinse water return and must be connected for system to function correctly.
Reverse Osmosis Module Mounting
Step 12
Turn off the cold and hot water supply to the faucet by turning the angle stop valves completely
off. Open cold and hot water sink faucet to relieve pressure.
Step 10
Step 11
Choosing the configuration that fits your plumbing, attach the adapt-a-valves as illustrated in
the photos above.
Adapt-a-Valve Installation
Do not use Teflon tape with the Adapt-a-Valve. WARNING:
3/8” Configuration
(With Brass Fittings)
* Insert White Washer
1/2” Configuration
(Without Brass Fittings)
*
White
Washer
Hot
Supply
Cold
Supply
Verify contents prior to installation:
( 2 ) - Plastic Adapt-a-Valve with black collet
( 2 ) - Brass Adapter no washer
( 2 ) - Brass Adapter with black washer
( 2 ) - White rubber washer
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve.
Don’t forget to install the white compression washer with the 3/8” configuration.
Brass adapter (A) does not need to be tightened with a wrench, only finger tight.
Black
Collet
A
TIPS:
A
White
Washer
Connect the Green and Red Tubing
Step 13 In the parts bag locate the 1/4” green tubing. Insert one open end of the green 1/4” tube into
the open 1/4” quick connect fitting on the COLD
water feed adapta-a-valve making sure the
tube is pushed in all the way to the tube stop. Repeat the procedure to connect red tubing
attached to the RO module to connect to the hot water, return adapt-a-valve.
Determine best location for the RO module to be mounted to allow
for future system maintenance. Using the mounting holes on the
bracket, mark the location for the mounting screws on the cabinet
wall under the sink. In the parts bag, locate the two self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet at the marked location. Hang the module on the screws
using the mounting holes in the bracket