11
5.1.2 Multiple controller’s installation.
If there are multiple interconnected controllers in the installation, there are 1 main-controller and up to 3 sub-controllers.
The main controllers centralizes the information for the sub-controllers. If a WFC-03 HCM RF 230 is used, it should be
paired to the main-controller.
• The main-controller propagates the Heat and Cool mode to the sub-controllers. This information could come from the
WFC-03 HCM RF 230 or from a Master Digital thermostat according to the DIP4 and DIP5 (See 3.3).
• The main-controller could handle the pump signal of the whole installation according to DIP1 (See 3.3).
BT-D03 RF
Main
WFC-03 HC RF
Sub
WFC-03 HC RF
Sub
WFC-03 HC RF
Sub
WFC-03 HC RF
BT-WR02 RF (Option)
WFC-03 HCM RF 230 (Option)
BT-A03 RF
Device 1
Device 2
Remarks
By pressing
for 5 seconds, the
controller goes in RF pairing menu.
By using
and
select zone 3
(Red led), press
to enter in Pairing
with a slave device mode.
All LEDs are blinking green.
Put the device in RF pairing mode.
When link is done WFC-03 HC RF and
BT-WR02 RF return to pairing mode.
This configuration allows a remote pump
output.
Exit of the controller pairing menu: Long
press on
.
By pressing
for 5 seconds, the
controller goes in RF pairing menu.
By using
and
select zone 3
(Red led), press
to enter in Pairing
with a slave device mode.
All LEDs are blinking green.
Put the RF repeater in RF Link mode
(press 3 seconds on the button).
When RF link is done, WFC-03 HC RF
returns to pairing mode and the led on
the repeater becomes green fix.
Exit of the controller pairing menu: Long
press on
.
Led position
Key position
