Dimensions: 3-3/8" x 3-3/8"
The Watts Radiant DualTemp thermostat has the ability to sense
the temperature of the air, fl oor or a combination of air and fl oor.
Each DualTemp comes with an internal air sensor. An OPTIONAL
external 10k sensor which allows detection of fl oor temperatures may
be ordered separately. The external sensor does not have to be used if
the DualTemp is to detect air temperatures only.
For Residential and Commercial Applications
08-04
Job Name ––––––––––––––––––––––––––––––––––––––––––– Contractor
––––––––––––––––––––––––––––––––––––––––––––
Job Location ––––––––––––––––––––––––––––––––––––––––– Approval
–––––––––––––––––––––––––––––––––––––––––––––
Engineer –––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval ––––––––––––––––––––––––––––––––––––––––––––– Representative
––––––––––––––––––––––––––––––––––––––––
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials
without prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
4 4 2 2 6 7
NTC A/B
Wall Anchor Point
Power Connections
Electrical Access
Optional Sensor Connections
Optional Floor Sensor
Screw Cover
Cover Screw
+/- Adjustment and
Temperature Set Buttons
Mounting Screw
Base
Digital Display
Cover
DualTemp Digital Thermostat
DESCRIPTION PROPERTY
Operation Voltage
24V
Contact
10A, 230Vac Relay
Sensor
NTC 10K Thermistor
Static Differential
1°F
Proportional
10 minutes for 3.5°F
Built-in manual setback
7°F
Air Temp Range
41- 99°F
Floor Temp Range
41- 99°F
°C °F
10 50.0
15 59.0
20 68.0
25 77.0
30 86.0
35 95.0
Installation & Operation
To mount the thermostat remove the thermostat cover by removing the
white Screw Cover (located in the center of the thermostat cover) and
the Cover Screw. Secure the Base Unit to the wall. Be sure to feed the
electrical wiring (18-3 or 18-4) through the provided slot in the Base Unit
and connect to appropriate terminal block(s). Replace the Cover, Cover
Screw and Screw Cover.
If fl oor sensing is desired, make sure the fl oor sensor is connected to
the corresponding fl oor sensor terminals (labeled NTC, the fi rst two
terminals on the right terminal block). It may be necessary to adjust the
J6 setting. See wiring diagrams for details.
Changing Values
To enter the pa rameter menu, press and hold the
OK
button for 5 seconds.
Use the +/- keys to select the installation parameter to be adjusted. Press
OK
to
toggle the parameter setting or to edit its value. When the value begins to blink,
use the +/- keys to adjust its value. Press OK to select the adjusted value. Use the
+/- keys to select the next parameter and repeat.
Toggle to “End” and press OK to exit the installation parameter menu.
DualTemp Thermostat with opitonal fl oor sensor.
Product Options
Qty
Description
Model #
Order #
DualTemp, 24V Digital, Air/Floor
P-3285
81009395
Floor Sensor, 10K
500802
81000505