Watts Battery WBX 1, Руководство пользователя

Страница: 6 / 36

OWNER’S MANUAL - WATTS
charged for at least 4 hours (the full charging
timemay vary depending on the capacity and
the device discharge level). To do this, connect
the module to the network without load.
If the battery is completely discharged or the
module has not been used for three months
or more, it is also necessary to fully charge
the battery.
Install the module in a temperature-controlled
room, in a place with good ventilation.
During operation, the temperature of the
housing may rise to 45 °C (113 °F), which is
normal.
The power of the connected load must not
exceed the rated power indicated in the table
of technical specifications.
Do not connect WATTS directly to
photovoltaic (PV) solar wiring.
Consult a qualified professional if you need to
connect WATTS to (PV) solar panels.
Do not connect WATTS directly to the
photovoltaic (PV) solar wiring, without
using protection devices and automatic
disconnection.
Batteries in WATTS are not replaceable.
Contact the Watts Battery Authorized Reseller
who sold the WATTS for any repairs.
Do not open the batteries: deformation of the
cell may cause a fire.
Never use WATTS under the following
conditions:
- in dusty and flammable gas rooms;
- at temperatures above 40 and below -20
degrees Celsius;
- at a relative humidity level of more than 90%;
- during condensation of moisture in the room;
- in direct sunlight or near heating elements;
- in places with insufficient ventilation
(cooling);
- in places with increased vibration.
- in gas distribution points.
Failure to comply with the operating
conditions of the device will shorten the
battery life.
Do not use with medical equipment and life
support equipment. Under no circumstances
should this device be used for medical
purposes, including life support or patient
care equipment.
Do not make any changes to the device.
When installing in a garage, make sure that
WATTS is seen from the vehicle and that it
will not be hit by the bumper.
Be careful not to block the air vents with
newspapers, tablecloths, or curtains that
interfere with normal ventilation.
Do not leave WATTS outside during rain or
cloudy weather.
Do not leave WATTS in direct sunlight.
When using the device outdoors, make sure
that water droplets, dust, dirt, and insects do
not get into the device.
In fire extinction, use a powder fire
extinguisher only; Using water can cause
electric shock.
Do not use the module in medical facilities or
in rooms where medical equipment is placed.
Radio waves can interfere with the operation
of medical equipment, which can lead to
accidents due to equipment failure.
Do not use the module near automatic control
equipment, such as near automatic doors
5