Using the digital operator
Page 48 / 52
Function
Display *)
Function description / parameter setting range
Standard
setting
Set
values
Programmable digital outputs
Digital outputs can be assigned one of 6 different signalling functions. Both outputs may also be assigned to the
same function. The outputs can be programmed either as normally closed contacts or as normally open contacts.
Function of
digital output 11
C 21
N
One of the following signalling functions can be assigned:
00: RUN signal (signal active during motor run)
01: FA1 signal (frequency arrival)
02: FA2 signal (frequency exceeded)
03: OL signal (overload)
04: OD signal (PID-deviation exceeded)
05: AL signal (alarm signal)
01
Function of
digital output 12
C 22
N Refer to
C 21
for possible parameters
00
Function of
FM terminal
C 23
N
The FM output terminal can be used to output one of the
following values:
00: Output frequency display (analog signal 0–10VDC)
01: Motor current display (analog signal 0–10VDC;
100% of the rated current corresponds to 5VDC)
02: Output frequency (digital pulse signal)
00
Digital output 11
type
C 31
N 00: Normally open contact 01: Normally closed contact
01
Digital output 12
type
C 32
N Refer to
C 31
for possible parameters
01
Type of
alarm relay output
C 33
N Refer to
C 31
for possible parameters
01
Level for overload
signal
C 41
N
Motor
current
C 41
OL signal
Inverter
rated
current
Arrival frequency
FA2 for acceleration
C 42
N
f
C 43
FA2 signal
C 42
0.0
Arrival frequency
FA2 for
deceleration
C 43
N
(The digital output terminal 11 or 12 configured as FA2 will
remain activated during deceleration as long as the actual
frequency is above the frequency entered here (also refer to the
figure under
C 42
).
(Setting range: 0Hz–360Hz)
0.0
Level of PID
deviation
C 44
N
OD signal
C 44
C 44
Actual value
Set value
3.0
Содержание L2000 Series
Страница 1: ...INVERTER Series L2000 M A N U A L NB596XA...