CAUTION :
-
Make sure the heater is completely submerged in water and then place the heater in the
desired position (see image 2).
-
Do not pull the power cord sharply. To remove the plug from the outlet, gently pull on the plug
directly, not the cord.
-
If the power cord or glass is damaged, the heater should be disposed of.
-
Make sure your hands and the plug are dry before removing the plug.
-
If the heater emits an unusual smell or noise, unplug it immediately.
-
Do not use the heater for any purpose other than that intended by the instructions.
WARNING :
-
Unplug or turn off all appliances in the aquarium or tank before servicing.
-
Do not repair or modify the heater, as this may interfere with the operation of the filter.
-
For indoor use only, not in a bathroom.
-
Keep this product out of the reach of children.
-
Unplug or turn off all aquarium or pond equipment before servicing.
-
This waste should be collected separately for special treatment and should not be disposed of
with household waste. This product should be disposed of at the waste disposal center or at
an authorized recycling site for electrical and electronic equipment.
Instructions for use :
-
It is important to choose the power of the heater according to the size of the tank.
-
Then, it is necessary to set the heater to the desired temperature.
-
The heater will then automatically heat to the chosen temperature. For example, if you set
your heater to 28°C, it will heat the water to this temperature and maintain it.
If the heater having been put to work over 24 hours, and water temperature is lower or higher than
set temperature, please check the following points :
➔
The reading of the thermometer is accurate
➔
Power has been switched on
➔
The temperature has been correctly set
➔
The water surface is above the water level on the heater
➔
The tank volume matches the power of the heater
➔
The water circulates well, do not put the outlet of the pump directly to the reading window of
the heater. If unavoidable, please slow the bow down.
2
