Step-by-step plan for installation
1.
Read the manual.
We offer you a manual that is as complete as possible. This includes items that are not related to the
WaterWorld engine, but to the whole boat, the propeller and the batteries. However, each
installation is customised and must be installed by a competent person
.
2.
Check that you have received everything included in the scope of delivery.
See page 18. Lay everything out clearly and compare it with the list in chapter 4 of this manual and your
packing list. If you have any questions, please contact your supplier immediately.
3.
Prepareer de boot om in een schone en droge omgeving het systeem aan te kunnen leggen.
If the following points are not in order, they must be rectified before installation.
•
No permanent bilge water where the engine is installed.
•
Good protection against flooding of the boat, such as a functioning bilge pump in the right place in the
boat.
•
When installing components, also consider leakage or condensation from above. For this reason, a
component may have to be placed somewhere else or covered from above.
•
Ensure that the space or spaces in question are well ventilated so that moisture can evaporate and leave
the area.
•
WaterWorld has developed a highly efficient motor that can do without air cooling. It is very important,
however, that sufficient cold air can enter and hot air can be released.
•
A smooth-running propeller shaft system. A badly running propeller shaft system will cause the following
problems:
•
Higher consumption, resulting in shorter sailing time
•
Overheating of the engine
•
Reacting to acceleration
•
Less throttle control, the engine will start with too much capacity once it has enough power
4.
Choose the right propeller.
Please see our advice on page 44.
5.
Check the accessibility of the components.
Will all components be accessible in the future so that everything can be serviced?
PRE-INSTALLATION CHECKLIST
Step-by-step installation plan
6.
7.
8.
9.
10.
Ensure good weight distribution in the boat.
The (lead) battery pack is heavy, ensure proper weight distribution in the boat. Make sure that the batteries
are accessible for servicing the battery poles, wiring and, in the case of wet batteries, filling them with
distilled water.
Choose the right thickness of cabling.
For cable selection, see page 27. Ensure that cable lengths are not unnecessarily long where this can be
prevented.
Read the safety instructions in chapter 3 before you start to connect anything.
Then read the section of the manual concerning that component. Always connect according to the connection
diagram on page 23.
Start installation.
Complete the online checklist.
In order to ensure the proper functioning of the system, the checklist in the Annex must be completed online
at
www.ww-el.com
10
11
