Main switch
Install the main power switch in an easily accessible place in the (red) + cable between the motor
controller and the batteries, so that in case of emergency or maintenance the system can be easily
disconnected from the batteries..
Relais
Install the supplied relay in the (red)
+ cable, between the motor and the main
power switch.
The loose red cable with M8 eye connects
to the relay bolt on the battery side. Make
sure that this red cable is well connected,
as a bad connection can lead to engine
failure when starting the engine.
The relay has a plug with 3 wires, which is
connected to the controller on the mating
plug. This has the same colour wires and
fits only one way.
Once the system is installed, make sure the main switch
is always OFF (“0”
or “off”
position)when working on the components and when disconnecting the power
cables.
Throttle
DANGER
ATTENTION!
The main switch must be switched off when charging the batteries.
Main fuse
Mount the main fuse between the main power switch and
the + pole of the batteries, as close to the battery as
possible, preferably in the battery compartment.
1.
Mount the throttle in the appropriate place, well accessible to the driver.
Ensure that the throttle is mounted in such a way that the boat's crew cannot
easily bump into it, causing sudden departure or acceleration!
2.
Fit the throttle in such a way that, in the neutral position, the throttle is
vertical.
WARNING!
Make sure that this main fuse is inside the boat, but
remains visible by opening a hatch. The capacity of the
fuse in amperes should be about 1.6 times the maximum
amperes of the engine (see specifications).
You can order an ANL fuse ANL fuse with the system.
We supply the following values:
WaterWorld 4.0 kW
–
160A
WaterWorld 7.5 kW
–
250A
