Your Osprey Power Shower has been designed, manufactured and carefully tested, in
England.
If correctly installed and not misused, it will give many years of reliable ser vice.
To ensure satisfactor y operation, we ask that you read the instructions before
commencing installation. Then carr y out, in sequence, each step as described.
The
Important Instructions
MUST
be followed, other wise the shower will be
damaged and your guarantee may be invalidated.
20 Minute Rating
Your shower is fitted with an auto resetting safety thermal cut-out. If it is left running
for over 20 minutes, the thermal cut-out may switch of f. The thermal cut-out will
automatically turn on again when the motor has cooled down.
1.
WARNING
– The
cold
water
must
be connected to the
top
inlet valve. The
hot
water
must
be connected to the
bottom
inlet. Incorrect connection will prevent
correct operation of the system.
2.
Do not connect to mains water pressure.
The Osprey power shower cannot be
used with combination boilers.
3.
A minumum supply head of 1 metre is required.
The water level in the cold
water storage tank should be 1 metre above the unit.
4.
Do not use any jointing compounds
such as Boss White. Abrasive compounds
will block the control valve and also damage the pump seal.
5.
Solder Flux
must not be allowed to come into contact with any of the plastic
par ts. Flux will seriously damage the plastic.
6.
Solder
Do not solder pipes, etc near to the unit as excessive heat will melt the
plastic par ts.
7.
Flush out pipework
Before connecting the water pipes, thoroughly flush out all
new pipework.
8.
Flat Surface Mounting
The base must be mounted on a flat sur face,
other wise the unit will be distor ted and the cover and control knob will not fit
correctly.
9.
Do not run unit dry
Both the hot and cold water supply must be connected and
working before switching on electricity and operating the power shower.
1. GENERAL
2. IMPORTANT INSTRUCTIONS
3. POSITIONING THE SHOWER
1
Locate the best position for the unit and the riser rail ensuring that the shower
outlet is placed to give the best shower ef fect; usually the centre of the shower
cubicle wall or end wall of the “bath/shower”.
