Watermark rainsaver Bianco RainsaverMK4E, Инструкция по установке и эксплуатации

Страница: 6 / 16

INSTRS110110 rev 6 01/03/15 Page 6
4.6 Pressure Tank Outlet
The
RainsaverMK4E is supplied with an additional outlet specifically designed for the installation of a
pressure tank.
The installation of a pressure tank will:
- Reduce wear and tear on your pump by significantly reducing the number of starts
- Reduce your electricity consumption by significantly reducing the number of starts
- R
educe the incidence of “pressure drop” when opening a tap
- Stop your pump kicking in every time you open a tap or because of a small leak, like a
dripping tap, or toilet cistern.
To install a WATERMARK approved pressure tank:
- Turn off both mains water supply pressure and your rainwater tank pump and supply
- Open a tap to remove all pressure from the system
-
Using the spanner supplied, remove the ¾” plug from the “A
UX. OUTLET
”
port. Note that
there is an o-
ring inside the body of the Rainsaver which can be left in place if using a ¾”
BSP fitting, or removed if using a ¾” BSPT fitting.
- Use a suitable fl
exible reinforced hose with ¾” BSP
or BSPT MALE THREAD to connect
a WATERMARK approved pressure tank such as a GWS Energy Saver to your
RainsaverMK4E.
- Carefully follow the manufacturer
’
s instructions regarding pressurization of your
pressure tank.
4.7 Pressure Tank Pre-charge.
To ensure optimum performance and system life, the Pressure Tank pre-charge needs to be set by
filling the pressure tank with air through the air valve so that the air pressure is 65% of the pump
maximum pressure.
Pre-charge the pressure tank before it is installed by using an air pump or using the local service
station facilities.
Cautions:
In conjunction with this manual, read and understand the installation and maintenance manual for the
water pump that is to be connected to the
RainsaverMK4E .
The
RainsaverMK4E and any pump connected to it are not to be used by children or infirm persons
and must not be used as a toy.
If the supply cord is damaged, it shall be replaced by the manufacturer or its service agent or similarly
qualified person in the order to avoid the hazard.
Mains plug shall be connected in to an appropriated IP rated socket outlet (Note: This requirement is
necessary as to meet the requirements of the equipment mounting outdoors)
A licensed plumber should carry out plumbing connections.
Servicing of the RainsaverMK4E and, or water pump should only by carried out by qualified persons.
Do not clean the
RainsaverMK4E with abrasive or petroleum based fluids, and do not use
hydrocarbon propelled sprays on or around the RainsaverMK4E .