Watermark rainsaver Bianco RainsaverMK4E, Инструкция по установке и эксплуатации

Страница: 4 / 16

INSTRS110110 rev 6 01/03/15 Page 4
4.22 Pump Mounting:
RainsaverMK4E
can be mounted directly onto the outlet of the pump with the adaptor supplied. If
another size threaded port is found on the pump or controller outlet use quality standard plastic
threaded pipe fittings to adapt.
Pump Mounting Instructions:
-
Remove wall mounting bracket by unscrewing the lower (Pump Inlet) union nut using the
plastic spanner provided. Remove the union nut and pipe being careful not to lose any of
the internal components.
- Unscrew the two bracket holding screws and remove the bracket.
- REPLACE THE BRACKET HOLDING SCREWS into the housing. This will stop insects
creating a nest inside the Rainsaver Unit.
- Replace the lower union nut and pipe being sure that internal components are in place
and that the o-ring is properly seated.
- Leave the lower union nut slightly loose to allow fitting and alignment to pump.
-
Attach the ¾” BSPT
male pipe fitting to the pump outlet, either directly, or using plastic
threaded pipe fittings as required, and tighten using the spanner provided.
-
Once the ¾” BSPT pipe fitting is secured to the pump and the
RainsaverMK4E aligned
as required, tighten the lower nut with the plastic spanner provided.
Note: Tank outlet should be 100mm from the bottom of the tank. See ARID handbook.
Note: The female socket from the Rainsaver must hang down.
Note: It is recommended that all surface mounted pumps be protected from the elements.