Watermark Puretec WH1, Руководство пользователя

Страница: 6 / 8

6 Installation & Operation Manual Copyright © Puretec Pty Ltd 2021
Maintenance
Wall Mount Bracket
Filter Housing Head
O-Rings
Filter Housing Bowl
Housing Spanner
3 Clean bowl(s) with soap and warm water and rinse thoroughly. Check O-Ring(s) for
damage and if there is any, replace.
4 Check O-ring(s) lubrication and if necessary apply a light coating of food grade
silicone lubricant (or similar).
5 Remove all packaging from new filter cartridge(s) and insert into housing bowl(s)
making sure cartridge(s) is properly seated over spigot in base of bowl(s).
Remember to record the model no. of the cartridge(s) you use.
6 Hold bowl(s) upright while screwing onto head. Make certain that the spigot in the
housing head(s) is located centrally to the cartridge(s) to make a good seal. Hand
tighten bowl until firm. DO NOT OVER TIGHTEN.
7 Open downstream tap to allow air to be released and gently open water supply
allowing all air to be purged.
8 Allow water to run for 2 minutes to flush the system.
9 Close down stream tap and check for leaks. Flush system for 10 minutes after any
period of non-use more than 2 days. For a period of non-use of 2 weeks or more,
it may be necessary to replace the cartridge.
Replacement Parts List
345
345
150
209 150
209 345
209 345