WaterLogic WL800 - MAX II, Руководство по эксплуатации, установке и обслуживанию

Страница: 9 / 75

Control Panel Instructions
The above picture shows front LCD display and control panel for the Waterlogic WL800 .
Button Operational Use
Heating LED is on when heater is working
Chilling LED is on when cooling system is working
UV
LED is on when UV sterilization light is on. UV
sterilization filter has UV light inside. Water runs
through UV sterilization filter and UV light sterilizes the
water. UV light is on when nobody uses the device for
more than an hour. UV indicator is on when UV light is
on. The UV recirculating system starts when the WL800
is idle and unused for one hour. The UV system will
operator for 1 hour every 4 hours that the WL800 is
idle. (1 hour ON, 3 hours OFF).
Service
LED is on when a water leak is detected. Contact your
Service Center as soon as you find the Service LED on.
Sleep Mode
Button
Sleep mode is defaulted to OFF. If you would like to
place the WL800 into sleep mode manually, depress
the sleep Mode Button. After 72 hours, if the WL800
remains idle and unused, the unit will enter sleep
mode. To awaken the WL800 from sleep mode, you
will need to dispense 20 ounces of water from the
machine (hot or cold) which will start the hot tank
heater.
Sleep Mode Button
WL800 Operating, Installation, and Service Manual Page 9 - Revision: 5-14-2015