WaterLogic WL800 - MAX II, Руководство по эксплуатации, установке и обслуживанию

Страница: 40 / 75

Always install indoors and place the
Waterlogic WL800
on a firm, flat and stable surface.
Attach the water supply line to the 1/4” feed water inlet bulkhead fitting on the back of the unit.
Waterlogic requires the use of a water pressure regulator. Water feed pressure must be between 40-
60 psi. Turn on the water supply and check for leaks.
1. Connect the power cord to the back of the Waterlogic WL800 and to a 120 Volt supply.
2. Allow unit to fill.
3. Dispense Cold Water
4. Dispense Hot Water
5. Move the Waterlogic WL800 into its final operating position. Be sure that a minimum of 2”
clearance is maintained around both the sides and the back of the unit. This is important to allow
proper airflow and heat exchange of refrigeration system.
6. Level unit using the adjustable feet to level if necessary. Never install on incline.
7. Once the unit is at the target temperature(s), sample the water to ensure water meets expectations
and additional rinsing or adjustment is not required.
8. Check the unit for any leaks. External Leak Protection is always recommended.
WL800 Operating, Installation, and Service Manual Page 40 - Revision: 5-14-2015