WaterLogic WL3000, Техническое руководство

Страница: 12 / 31

22 23
WL3000 Technical Manual - May 2014
Programming Instructions
Programming of the WL 3000 will depend upon the type of the machine:
The buttons have the following functions:
Button 1 Scroll the menu down
Button 2 Scroll the menu up
Button 3 Enter an option on the menu
Button 4 Escape to main menu / Exit programming
To access the programming menu press the two buttons 1 & 2 together for 3 seconds
until the message “COLD TEMP SET” appears on the screen.
Note: If no buttons are pressed within 5 seconds, the display will exit the programming
mode (e.g.“COLD”)
EXAMPLE: CHANGE THE LANGUAGE FROM ENGLISH TO FRENCH:
1. Press buttons 1 and 2 for 3 seconds, until “COLD TEMP SET” appears on the
display.
2. Press button 2, until the menu scrolls to the option “LANGUAGE”.
3. Press button 3 to select the option.
4. Press button 2, to scroll through the languages (English, French and German).
5. Press button 3 to select “FRENCH”.
6. To return to the main menu press button 4.
7. To exit programming press button 4.
See next pages for Full Menu Options
The programming board is located underneath the front door, attached to the top
cover and connected by a long cable. To open the door, undo the screw, located in
front of the dispense nipple. Lift and tilt the front door panel towards you. Remove
the programming board from the holder, and replace the front door.
Note: The door will not close completely due to the cable extension).
The buttons on the board have the following functions:
PREV (+) Scroll the menu down
NEXT (-) Scroll the menu up
MENU/ENTER Enter an option on the menu
ESC Escape to main menu/Exit programming
To access the programming menu press the two buttons
PREV (+) & NEXT (-)
together, for three seconds until the message “COLD TEMP SET” appears on the
screen.
Note: If no buttons are pressed within 5 seconds, the display will exit the programming
mode (e.g.“COLD”)
EXAMPLE: CHANGE THE FILTER TIMER FROM 6 TO 9 MONTHS:
1. Press buttons PREV (+) & NEXT (-) for 3 seconds, until “COLD TEMP SET” appears
on the display.
2. Press NEXT (-), until the menu scrolls to the option “FILTER TIMER”.
3. Press button MENU/ENTER to select the option.
4. Press button NEXT (-), to scroll through the options (3 months, 6 months, 9 months).
5. Press button MENU/ENTER to select “3 months”.
6. To return to the main menu press button ESC.
7. To exit programming press button ESC.
See next pages for Full Menu Options
Panel shown is for Cold, Sparkling, Hot and Extra Hot
COLD, SPARKLING, HOT AND EXTRA HOT
COLD, HOT AND EXTRA HOT
COLD AND AMBIENT - COLD AND SPARKLING - COLD ONLY
COLD 8°C
1 3 2 4