WL1000GF MAX
Manual
Page 17 Revision 10-7-2017
DIP SET-UP FILTER TIMER
Factory Setting is None
Filters should be configured to optimize your system. Filters need to be configured and specified to do
the job given the local water conditions, usage, maintenance schedule, and placement restrictions.
In order for our filters to perform as represented and to provide the best quality
water possible, it is essential that filters be replaced periodically. The frequency
of filter changes depends on your water quality and your water usage. For
example, if there is a lot of sediment and/or particles in your water, then you will
have to change your filters more frequently than a location with little to no
sediment. Be sure to replace your filters whenever you notice a decline in the
performance, whether it is a drop-in flow rate and/or pressure or an unusual
taste in the water.
DIP SET-UP SLEEP MODE (ENERGY SAVER) When in Sleep Mode when there is no incoming water for
more than three hours, the
WL1000GF MAX Water Treatment System
will go to sleep mode
automatically and the Red Sleep LED light is on and the heater is turned OFF.
Sleep Mode Factory Setting OFF
After Filter Change –
push reset button
located on back of the
WL1000GF MAX
