P2 Classe
Manual
Page 36 – Revision: 3-2-2021
Remove Plug
To Drain
DRAINING INSTRUCTIONS
WARNING!
STORE UNIT EMPTY. ALWAYS SANITIZE BEFORE REUSE.
The unit must be completely drained and sealed before storing to avoid stagnation and
reduce microbial growth).
1.
The
P2 Classe
has two main parts to drain, the Still/Sparkling water lines, and the Ice
Bath. Draining instructions for both parts are below.
2.
First,
SHUT OFF
the water supply to the machine.
3.
Close the valve on the CO
2
bottle.
4.
To drain the
P2 Classe
Ice Bath, remove the 1/4” plug, that is inserted into the drain
bulkhead located on the rear of the machine. *
Upon removal of the plug, water will
begin draining from the ice bath. Have a container prepared to catch the water, or back
the machine up to a sink or drain basin.
This operation will take upwards of 20-30min
to fully drain the ice bath.
5.
To drain the Still water line of the
P2 Classe
, (with the Gas Bottle shut off) disconnect
the gas line from the CO
2
inlet. Disconnect the water supply line from the water inlet of
the unit. Now plug the gas line into the water inlet of the unit and open the valve of the
Gas Bottle. Simply hold one of the Still Water dispense button to drive water out of the
still water line until it is empty, and gas is escaping. Shut off the valve of the Gas Bottle
and reconnect to the CO
2
inlet of the unit. Once reconnected, do the same for the
Sparkling Water line, holding the Sparkling dispense button until the dispense line is
empty, and it begins to gas.
6.
Turn the Red Compressor Switch to the
O=OFF
position immediately after draining the
sparkling line.
