Waterfall Audio RS700, Инструкция по эксплуатации

Страница: 5 / 34

- 2 -
IMPORTANT SAFETY INSTRUCTIONS
AND WARNINGS
Safety symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to
alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure. This
voltage may be of sufficient magnitude to constitute a risk of electric shock. The exclamation mark within
an equilateral triangle is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the product.
Before installing your RS700 amplifier, it is imperative to read this manual entirely. Follow and keep
these instructions. If in any doubt about the configuration or any of the connections to be made, consult
your dealer.
- Do not expose the device to moisture, dripping or splashing.
- Do not introduce foreign objects into the device.
- Do not use the device near heat sources such as radiators, heaters, etc.
- The power cord supplied with the device corresponds directly to the power requirements. It
should never be replaced by one of a lesser capacity.
- Only connect the device to the type of connector indicated by the labeling on the device.
- Before connecting the device to the mains, ensure that your electrical installation can provide
sufficient power and is earthed. If you are unsure, consult your electrician.
- If the power cord does not fit your AC outlet perfectly, consult an electrician and replace the outlet.
- The power cord must not be trampled, crushed or pinched.
- The wall outlet that the RS700 is connected to must remain accessible.
- Do not overload wall outlets or extension cords this will create the risk of fire or electric shock.
- Risk of Electrocution - Never open the appliance whilst it is connected to the mains
- Take great care when making the required internal configuration of the amplifier, it must be
disconnected from the mains and the cover properly replaced before testing. Never operate
the internal switches when the device is connected to mains power.
- "Power off" the amplifier when not in use. In case of thunderstorms or if the device is not to be used
for long periods of time ensure that it is unplugged at the power outlet (24).
- Ventilation: Ensure that fan outlets are never obstructed and that there is adequate ventilation to
allow cooling. Keep the air intakes clean by periodically removing the air intake grilles, carefully
cleaning them and replacing them.
- Fuse: In the event of a complete failure, check the mains fuse (after disconnecting the device from
the mains). When replacing fuses use exactly the same specification as the original, NEVER use a
higher rated fuse. If the problem persists, contact your reseller.
- Never short a speaker output terminal/wire (21) of the amplifier to ground or to the chassis.
- Never swap the + and - of the speaker outputs (21) between the right channel and the left channel.
- Connect only one speaker per speaker output. Never connect multiple speakers or subwoofers
either in parallel or in series on the same channel.
- Never change the configuration switches (5, 6, 7, 8, 9) when the "Mute" switch (4) is set to 1.
Changes may only be made when mute is set to position 0.
- The “Prog” connector (2) on the front of amp is strictly reserved for manufacturer’s use only.
- Do not use accessories other than those supplied with the device or explicitly recommended by
the manufacturer.
- Transportation: The device must always ship in its original packaging. This device is heavy, be sure
to follow proper manual handling techniques.
- Ensure that all maintenance instructions are carefully followed
- Risk of Choking - Do not leave the packaging bags within the reach of children
- In the event of any technical issues or servicing, refer this device to your dealer and/or an
authorized technical service agent.
Note: Numbers shown in brackets refer to the diagrams in Section B: Getting Started
Failure to comply with these important safety instructions and warnings will
result in the immediate termination of the manufacturer's warranty.