Waterfall Audio RS700, Инструкция по эксплуатации

Страница: 14 / 34

- 11 -
4. TRIGGER CONTROL
DEVICE STANDBY AND POWER UP CAN BE CONTROLLED REMOTELY VIA THE TRIGGER INPUT. TO
IMPLEMENT TRIGGERING, IT IS NECESSARY TO :
- Connect your control system or processor to either of the 12Vdc 3.5mm jacks (22).
The other jack can then be used to pass the 12Vdc control signal on to another device.
- Set the “TRIGGER” operation selector (23) to the "ON" position.
- Turn the main power switch (11) "ON".
- Set the "MUTE" switch (4) to the position "1 ".
NOTE : when trigger control is enabled, it is not possible to turn on the device in the conventional manner.
5. MAINS CABLE AND CONNECTION
Designed with a "dual insulation" architecture, the RS700 amplifier is equipped with Class 1 protection,
this means that it
must be earthed . It is designed to operate with a mains voltage of between 100V and
240 V (50 Hz -60 Hz). It will automatically detect the voltage and adapt accordingly.
The mains cable supplied with the device is of heavy gauge (type H05VV-F 1.5MM2 -3G section 3*1.5²)
with an earth connection. Under no circumstances should it be replaced by a cable of lesser gauge
(including the export version) or by a cable that does not have a connection to the earth.
6. INSTALLATION
The RS700 can be installed in a 19-inch RACK. The device comes with 2 adapters and 4 screws; the
adapter flanges are mounted by simple screwing on the rear part of the front panel, ensuring that they
are adequately tight. Alternatively the RS700 can be set on a flat surface; 4 adhesive hemi-spherical pads
are included for this use.
Ventilation: Ensure that fan outlets are never obstructed and can dissipate heat sufficiently. The device
and its cooling have been designed for a maximum ambient temperature of 40°C running at full power.
7. MAINTENANCE
For exterior cleaning (after disconnecting from the mains outlet) , use only a soft, lint-free, dry microfiber
cloth which may be slightly moistened with a mild glass cleaning product. Never use products such as
solvents or detergents. Periodically (depending on the level of dust accumalation) the ventilation grilles
(10) must be removed and cleaned. This cleaning is done outdoors with compressed air (preferably
dehumidified and oil-free e.g. a compressed air aerosol can). It is also possible to use a vacuum cleaner to
clean the filters.
In time, depending on the dust levels where the device is installed, the interior and fans in the device can
become clogged. When necessary internal cleaning is also to be carried out outdoors with compressed
air (dehumidified and oil-free). If in doubt, take the device to your dealer or an authorized service agent.
8. GENERAL INFORMATION
A. DSP Implementation :
The on board DSP allows an optimal amp/speaker pairing for the speakers predefined within the DSP
which is implemented in the RS700 amplifier "Waterfall Audio Special Edition". It is still essential to strictly
adhere to the installation instructions and bear in mind the following: