Waterfall Audio RS700, Инструкция по эксплуатации

Страница: 22 / 34

- 19 -
Control panel settings in CINEMA-SPEAKER configuration
• Switch (6) must be set to "AN” analog input
• Set switch (5) to XLR or RCA depending on the type of connector used
• Switch (8) Filtering: Must be set to the FULL position
• The multifunction controller (3) controls the screen correction "CSC™" (cinema screen compensation).
• When the connections and settings have been made, turn on the device with the main power switch (11)
and switch MUTE (4) to position 1. The volume control (1) must be positioned at the lowest position (fully
counter clockwise) on start-up. Then adjust the volume accordingly.
Points to note :
• The volume control (1) adjusts the volume on the L&R channels simultaneously.
• Switch (7) Phase: Does not operate. By default leave it set to 0°.
• Switch (9) Processing is inactive when switch (8) Filtering is set to "FULL",
(do not use Position 1 or 2 for this application).
• XLR (18) outputs should not be used in this application.
• S/PDIF digital links (19) and (20) should not be used in this application.
• The amp powering the center channel can work either the L or R channel according to your preference,
the unused channel will remain inactive.
• The minimum position (fully counter clockwise) of the multifunction controller (3) sets the "CSC™"
correction inactive and is in essence "FLAT" mode.
CSC™ technology can be implemented via the digital
multifunction controller (3) on the front speakers. Apply the same level of correction on both amplifiers.