3
Press
Press
Pull
Installation Tips
How to Use the Quick-Connect Fittings
To connect:
1. There is an existing mark (Figure 1)
at the end of the tubing that you can
use to confirm whether the tubing
is fully inserted into the fitting. Push
the tubing into the fitting until you
reach the mark on the tubing.
2. If the tubing is not fully inserted, it
will cause leakage. When the tubing
is fully inserted, put the blue lock clip
on the fitting. It will lock the tubing in
place and prevent it from falling off.
3. If the tubing is too long, cut it to a
suitable length using a sharp utility
knife or pair of scissors. Cut the
tubing squarely and cleanly (Figure
2). Make sure the tubing is fully
inserted.
To disconnect:
1. Remove the blue lock clip from the
fitting.
2.
Use your thumb and index finger
to press down on the lock sleeve.
Use your other hand to pull out the
tubing from the fitting (Figure 3).
NOTE:
Please do not pull out the
tubing directly, or else it will damage
the fitting and cause leakage.
Figure 2
Figure 1
Figure 3
Mark for
Full Insert
Cut Cleanly
and Squarely
How to Drill a Hole into Your Sink or Countertop (Optional)
NOTE:
•
Please confirm if there is an existing hole available to install the connector. If
not, please drill a hole in accordance with the following steps.
•
If the countertop is thicker than 2.68 inches, the connector cannot be installed.
It’s highly recommended to watch the YouTube video “How to Drill a Hole” for a
better understanding of the process. There is also a sticker for your reference
when you drill the hole. Remember to wear safety glasses to protect your eyes
while drilling the hole.