11
Warning:
•
Do not store the system in a location exposed to direct sunlight, as this may
cause the aging of the product parts. Do not store or expose the system to an
area below 32°F.
•
Do not store the system near appliances with strong magnets, which can cause
fire, product damage, or circuit malfunction.
•
Do not place heavy objects on the system.
•
Do not allow young children to operate, touch, or climb on the system.
•
Do not place flammable or volatile substances near the system.
•
Do not place the system near heat sources or fire.
•
Do not put other sundries into the tank.
Precautions
Caution:
•
When the inlet water does not meet municipal tap water standards (including
large amounts of sediment, excessive oxygen in the water, etc.), a pre-
treatment device should be installed before the installation of this system.
•
The feed water pressure of this system is 29-87 psi. If the water pressure is
lower or higher, install a pressurizer or pressure reducer accordingly.
•
The flow rate will decrease when the ambient temperature is low, which is an
inherent characteristic of the filter.
•
Clean and replace the filter in time.
•
When the system is dispensing water, there will be a slight vibration and noise,
which is normal.
•
This system is designed for indoor use only. A floor drain should be located
within 1.5 meters of the system to avoid loss caused by water leakage and poor
drainage.
•
If the system will not be used for a long time, turn off the feed water adapter.
Discard the water in tank and the next tank of water when you use it again.
NOTE:
In the event of a water outage or pipeline maintenance, turn off the feed
water adapter. When the water supply returns to normal, turn on other faucets
to drain the sediment. Then turn on the feed water adapter. Otherwise, a large
amount of sediment may block the filter.
•
Applicable water quality: municipal tap water.
•
The feed water pressure of this system is 29-87 psi. When the water pressure
is lower or higher, install a pressurizer or a pressure reducer accordingly.
•
The recommended temperature range of the product is 39-100°F. Do not install
the system where the ambient temperature and water temperature are higher
than 104°F or below 32°F.
•
Check whether the tubing connected to the system is incorrect and aging.
•
Make sure all tubing is fully inserted to the point where you reach the mark on
the tubing.
•
Use only authorized WD-M5-G parts and filters.
Installation Precautions