7
Step 5:
Connect the Inlet Water Tubing
NOTE:
Confirm the tubing length you need first. Then cut the tubing if it is too
long, referring to “How to Use the Quick-Connect Fittings” on page 3.
NOTE:
•
Ensure that it is fully inserted to the point where you reach the mark on the
tubing.
•
It is recommended that you connect the pressure relief valve. Cut the PE tubing
Step 4:
Install the Drain Saddle
Feed Water
Adapter
Connect the other end of the white 1/4” PE tubing to the quick-connect fitting of
the feed water adapter. Pop the lock clip onto the fitting to secure the connection.
(Figure 12)
Inlet Water Tubing
1. Stick the foam seal on the front plate of the drain saddle. Ensure that the hole
of the foam seal is aligned with the hole of the front plate. Choose a spot on the
drainpipe that is convenient for installing the drain saddle (Figure 9).
NOTE:
It’s recommended to install the drain saddle on the vertical drainpipe.
2. Drill a 1/4” hole in the drainpipe. Be sure not to penetrate the opposite side of
the pipe.
3. Slip the front plate on one end of the tubing (without a mark) and insert the
tubing into the drilled hole for about 0.6” (Figure 10).
4. Position the back plate on the drainpipe by tightening the screws and nuts
evenly while leaving the tubing in the hole.
5.
Pop the lock clip onto the fitting to secure the connection (Figure 11).
NOTE:
In some areas, the drain tubing must be connected to the drainpipe
through the air gap. Consumers must purchase air gap accessories separately.
Figure 9
Figure 12
Figure 10
Figure 11
Foam Seal
About 0.6"
Back Plate
Front Plate