I
pg 02
Waterco Britestream LED Fibreglass Niche Pool Lights MK5
LED FIBREGLASS NICHE POOL LIGHT COMPONENT
IDENTIFICATION
INSTALLATION
• Locate the ideal position within the fibreglass pool wall surface that best suits the lights
installation ensuring this location is not more than 600mm below top of coping.
• Mark this position and using a 2.5” (63.5mm) holesaw drill a hole in the fibreglass pool wall
that will allow the light to be fitted.
• Remove the 2” BSP threaded nut, flange (outer) & outer gasket from the lights niche body and
the 20m power cable.
• Thread the 20m power cable from the inside of the fibreglass pool through to the outside of
the pool and insert the pool light niche body into the 2.5” (63.5mm) hole.
Note:
The inner gasket must be positioned between the pool light lens and the fibreglass pool
surface.
• Thread the 20m power cable into the outer gasket, flange and 2” BSP nut and install on
the exposed threaded light niche body. Tighten the 2” nut sufficiently to ensure the light
assembly is properly secured to the fibreglass pool wall and will not leak water.
Note:
Inspect and repair as necessary the fibreglass pool walls to ensure the inner & outer
gaskets are able to provide a water tight seal.
Note:
It is recommended that the pool light be fully immersed in water & the installation is
inspected for leaks prior to back filling the pool light/s installation area.
• The 20m power cable is now ready for connection to a Waterco single or multi connect pool
light transformer.
Note:
For further protection of the power cable the use conduit is an option.
2 x Gaskets
Gland Nut & Fitting
1 x Flange (outer)
1 x 2” BSP Threaded Nut
Flanged Light
Niche Body
Light Lens