waterchef.com
REPLACING THE FILTER CARTRIDGE
FILTER STATUS NOTIFICATIONS
6
1.
Turn OFF the water supply to the System by shutting off the Inlet
& Outlet Valves on the Flow Control Valve.
2.
Remove Umbrella Cover from the top of the Housing. Replace the
3 AAA batteries with new batteries. Reset the Intelligent Monitor
™
by pushing and holding the Reset Button on the monitor board
for 3 seconds. The GREEN LED lights will flash 3 times to
confirm reset.
(fig. G)
3.
Depressurize the System by pushing down on the RED Pressure
Release Button on the Top Cap of the Housing until ALL the air or
water pressure is completely released.
(fig. H)
4.
Press down on the Top Cap with both hands to unseat the Snap
Ring.
(fig. I)
Remove the Snap Ring by carefully grasping the
handle and pulling inward, then upward. The Ring should slide
completely out of the groove.
(fig. J)
5.
Remove the Top Cap from the Housing by lifting up on the Cap
Handles. Remove the old Filter Cartridge.
6.
Connect 3/8” O.D. Tubing (included with EVO100 System) to the
Drain Valve that connects to the inlet side of the Filtration System.
Run the hose to a floor drain or bucket then OPEN the Drain Valve
and flush out the bottom of the System.
The built-in Intelligent Monitor
™
measures water and flow rate in real-time, notifying you about remaining filter
cartridge life with simple color-coded LED notifications.
GREEN
Peak Operating
Performance
FILTER IS
GOOD
YELLOW
Under 10% of
Filter Life Remains
ORDER NEW
FILTER
RED
End of Filter Life
has Been Reached
REPLACE
FILTER NOW
(continued on following page)
AAA
AAA
AAA
Snap Ring
Pressure
Release
Button
Umbrella Cover
(underside)
AAA Batteries
Reset Button
Top Cap
I
H
G
J
