WATERAX
VERSAX Owner's Manual
11/2015
21
Installation
The following steps refer to figure 10
1. Remove the handle #1 from the base frame.
2. Install the frame extension #3 onto the base frame, ensuring a proper lock between the extension and
the quick release buttons.
3. Install the quick release buttons #2 into the frame extension #3 by pushing them into the tube until the
pins pop out into the access holes.
4. Install the handles #1 in the frame extension.
5. Install wheel #5 onto wheel bracket #10 using hardware 6, 7 &12. Note that over tightening the nylon
lock nut #12 will restrict the rotation of the wheel. When tightening, ensure that the wheel is free to move.
Ensure however that the nut is fully engaged onto the screw threads.
6. Install wheel bracket (now with wheel assembled onto it) onto the base frame using hardware #8, 9 & 11.
7. Install equipment pouch #4 onto frame extension #3 using the snap buttons and the Velcro straps.
Battery System (VS2-9EW Only)
Parts breakdown
1
3
4
7
5
6
2
Figure 11: Exploded view of the battery kit for the VS2-9EW.
ID ITEM NO DESCRIPTION
QTY
1 701308
BATTERY STRAP VERSAX
1
2 700673
PART-764 VRLA SEALED BATTERY 12V 20AH
1
3 800860
QADHNEO1X1/8 SELF-ADHESIVE STRIP
1.2
4 801280
SCREW 5/16-18X3/4 HEX CAP ZINC
3
5 800477
A-7586-2 WASHER 5/16 FLAT ZINC
6
6 701299
BATTERY BRACKET VERSAX
1
7 801285
NUT 5/16-18 HEX NYLON LOCK ZINC
3
-- 800921
PART-456 BATTERY BOOTS 8-2GA RED
2
-- 700026
RK-1733 PROTECTOR CAP
1
IMPORTANT:
Ensure that the handle #1 and the frame extension #3
are fully engaged with the quick release buttons. A misalignment or a
bad fit may result in the handle or extension slipping out of place and
dropping the pump which may result in serious injuries. Refer to figure 9.
