USER INSTRUCTIONS
7
12/2014
03/2018
7
23. To install the DOS,
three holes will need to
be drilled and tapped
on the side of the fan
cowl.
24.
If you’re using the DOS
bracket drilling jig,
install it on the top 8
mm hole and lock it in
place. Drill the three
holes with a #30 drill
bit.
25. Carefully tap all three
holes with an M4x0.7
tap. Important: use
tapping lubricant.
Fan cowl before drilling of 3 holes
Tapping lubricant
Drilling jig
26. If you are not equipped
with the drilling jig, you
can use the bracket to
position the holes. To
correctly position the
bracket and prevent
any interference, install
the DOS on the
bracket. Position the
assembly on the side
of fan cowl and ensure
that:
•
There is no
interference with the
carburetor shroud;
•
There is no
interference with the
spark plug cover;
•
The bracket lays flat
on the fan cowl (be
careful of the radius
on the fan cowl).
27. Mark the holes with a
center punch.
28. Remove the fan cowl.
Drill and tap.
8 mm hole
