USER INSTRUCTIONS
6
12/2014
03/2018
6
Tightening torque: 2.5-
3 Nm. Be careful not to
squeeze/pinch the
green wire.
18. If you are not equipped
with the timing
adjustment tool, fit the
stator plate so that the
oblong holes are
centered with the
crankcase threaded
holes; then rotate the
stator plate 1-1.5 mm
counter-clockwise and
tighten the three
screws. Refer to the
MK-3 Service Manual
for dynamic ignition
verification procedures
.
Timing adjustment tool
Stator plate adjustment, 1-1.5 mm CCW
Coil resting on tool
19. First pass the green
wire through the
crankcase hole and
then through the
grommet. Install the
grommet on the
crankcase.
20. Pull the green wire
through the grommet
and apply a dab of
RTV silicone sealant.
21. Install the flywheel
assembly. Ensure that
the key is properly
installed. Apply Loctite
243 on the hex nut (R-
303) and tighten using
the fan/flywheel
holding tool (R-929).
Tightening torque: 45-
50 Nm.
22. Install the gasket pulley
and pulley.
