USER INSTRUCTIONS
4
12/2014
03/2018
4
Procedures:
1. Remove the 12-16
pump end.
2. Remove the fuel
connection and
disconnect the fuel line
from the carburetor.
3. On the carburetor,
rotate the fuel strainer
cover by 180 degrees
from position A to B
(see picture).
Position A
Position B
4. Remove the frame.
5. Use the Drilling Jig to
drill two 17/64” holes
on the right leg (see
images). If not
equipped with tool use
the hole pattern
provided. The CDI box
assembly will be
mounted on the left
and the fuel connection
will move to the right.
6. Remove the ON/OFF
switch and disconnect
the cut-out switch wire.
Discard.
7. Remove the ignition
cable clamp (#10).
8. Remove the fan cowl.
9. Uninstall and discard
the mechanical cut-out
switch and grommets.
10. Remove the pulley and
gasket.
11. If equipped with an
aluminum fan, use the
fan/flywheel holding
tool R-929 and remove
the nut (R-303) that
locks the flywheel
assembly onto the
crankshaft.
