Wateranywhere AAA-RO50PUVW, Руководство по установке, эксплуатации и техническому обслуживанию

Страница: 10 / 24

Installation and Service Manual – Under-the-Counter Point of Use 6 Stage Reverse Osmosis System with Pump & UV
Copyright © 2020 WaterAnywhere.
All Rights Reserved.
Page 9
Step 3 - Drain Saddle Installation
Notice: Some states require the use of an air gap faucet. Check your local plumbing code to
assure compliance.
For this step you will need:
o
Masking tape or duct tape
o
Variable speed drill w/ ⅛ ” and ¼" drill bits
o
Phillips Screwdriver
o
Drain saddle assembly supplied with system
o
White tubing cut to appropriate length
Select Location for Drain Saddle Installation
Select a location for the drain hole based on the design of the
plumbing. It should be installed above the trap and on the
vertical or horizontal tail piece.
Notice:
Do not install downstream of a garbage
disposal, as this can cause
contamination and system fouling.
Install onto a drain location without a
garbage disposal.
Drill a ¼” Hole in the Drain Pipe
Starting with the ⅛ ” drill bit, drill a ⅛ ” hole in the drain pipe.
Use the ¼” drill bit to enlarge the hole. Clean the debris from
the pipe and the hole before continuing.
Notice: Take extreme caution to not drill through to the other side of the drain pipe.
Install the Drain Clamp

Apply the foam gasket inside the front half of the drain saddle: Punch out
the cut-out hole in the center of the pad, remove the adhesive backing, and
adhere to the inside of the drain saddle, ensuring the holes are aligned.

Place one half of the plastic drain saddle assembly on each side of the
drain pipe with the fitting, and clamp loosely using the nuts and bolts
included.

Align the hole drilled in the drain pipe with the hole in the drain saddle. A
drill bit or other long narrow object may be used to help align correctly.

Use Phillips screwdriver to tighten the clamp. Avoid over-tightening.
Connect Drain Line to RO System Reject Line

Insert tubing to the pipe stop in the quick connect fitting on the drain line and
check the seal.

Connect the other end of the tubing to the flow restrictor outlet coming from the
membrane brine port.