The battery pack for your Pool Blaster has been shipped in a low voltage condition. It should be
charged overnight prior to use.
WARNING:
The Pool Blaster charger is for indoor use only.
WARNING:
Do not expose charger to excessive moisture or extreme heat or cold.
Charge battery only with the battery charger provided.
PRECAUTIONS:
•
Make sure power supply is normal household voltage, 120 volts,
60 Hz (240 volts, 50Hz International), AC only.
•
Do not handle Pool Blaster while charging with wet hands or without shoes.
•
Do not use or store your charger outdoors. Charge battery indoors in a clean dry
place. For best results, your Pool Blaster battery should be charged in a location
where the temperature is above 50 degrees F and below 100 degrees F.
•
Only use the charger supplied to recharge this vacuum. Do not use the supplied
charger with any other appliance or damage may occur.
•
Disconnect Pool Blaster from power charger when not in use.
•
Unplug the charger from outlet before any routine cleaning or maintenance.
•
The use of extension cords is not recommended. Plug the charger into a properly
grounded standard electrical outlet (120v/60Hz US, 240 volts, 50Hz International)
only.
•
To protect against risk of electrical shock, do not put unit charger in water or other
liquid.
•
To avoid damage to the charger and cord, never carry the charger by the cord or
yank to disconnect from an outlet. Instead, firmly grasp the charger body and pull to
disconnect. Do not pull cord around sharp edges or corners.
•
Do not allow the cord to hang over the edge of a table or counter or touch hot sur-
faces. The vacuum should be placed or mounted away from such hot surfaces
.
TO CHARGE
•
Turn the knob counterclockwise to remove the On-Off Knob. This will expose the
charging jack connection. NOTE: When removing the On-Off knob it is normal to
hear air escaping. The air inside has simply expanded from being heated by the
motor.
•
Connect the lead from the charger to the charging jack on the Pool Blaster.
•
Connect the charger to the appropriate electrical outlet.
•
After charging, ensure that the On-Off knob is fully secure and turned to the “On”
position before attempting to use your Pool Blaster.
CAUTION:
Replace On-Off knob after charging. Placing Pool Blaster in water
without replacing the knob will void your warranty.
BATTERY LIFE
•
The batteries are factory sealed in the motor box, and CANNOT BE REPLACED. Do
not attempt in any way to destroy or disassemble motor box or any of its compo-
nents. Under no circumstances should you attempt to open the battery pack and re-
place the batteries yourself. Your battery pack should give you many hours of use. If
your motor, batteries, or charger stop working, take the Pool Blaster to an authorized
service center.
•
NEVER LEAVE your Pool Blaster plugged in for long term storage.
After charging, the On-Off knob should remain disconnected from the unit and left hanging from
the attached lanyard.
CHARGING YOUR POOL BLASTER
