Water Specialist WS1.25CC, Руководство по эксплуатации и инструкция

Страница: 24 / 60

Page 24 WS1CC & WS1.25CC Manual
STEP 1US
STEP 2US
STEP 3US
➟
➟
RETURN TO
NORMAL MODE
Salt Remaining or Adding Salt
If the Low Salt Warning was activated in the last step of OEM Softener System Setup, the following screens will be viewed in the
User Display.
Note: The salt used per regeneration setting can be set in increments of 0.1 pounds, but the LBS REMAINING screen will round up
or down to the closest whole number.
Once the salt remaining has gone below the set point the display will automatically fl ash Salt Fill.
When adding salt to the brine tank (if the salt remaining feature is activated) the following steps must be completed:
➟
➟
or
Step 1US – Press the NEXT button until SALT appears in the display. It does not matter if the SALT
display alternates with the LBS REMAINING display.
Step 2US – Press SET CLOCK.
Step 3US – Set LBS REMAINING: Use the
▼
or
▲
button to adjust the pounds remaining in the brine
tank.
NOTE: Estimate the pounds of salt in the brine tank and add it to the amount of salt added to the brine
tank. The example at the left would indicate 200 lbs. of salt being added to a brine tank that has 40 lbs.
remaining.
Step 4US – Press SET CLOCK to exit Adding Salt.
STEP 4US
➟
Power Loss
If the power goes out, the system will keep time for up to 24 hours or until the battery is depleted. If
a power outage occurs, the time of day will fl ash on and off which indicates the time of day should be
reset. The system will remember the rest. If a power outage lasts less than 24 hours and the time of
day fl ashes on and off, the non rechargeable battery should be replaced.
Error Message
If the word “ERROR” and a number are alternately fl ashing on the display contact the OEM for help.
This indicates that the valve was not able to function properly.
➟
➟