Water Specialist WS1.25CC, Руководство по эксплуатации и инструкция

Страница: 23 / 60

WS1CC & WS1.25CC Manual Page 23
Regeneration Mode
Typically a system is set to regenerate at a time of low water usage. An example of a time with low water
usage is when a household is asleep. If there is a demand for water when the system is regenerating,
untreated water will be used.
When the system begins to regenerate, the display will change to include information about the step of the regeneration process and
the time remaining for that step to be completed. The system runs through the steps automatically and will reset itself to provide
treated water when the regeneration has been completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the
system calls for it, usually referred to as manual regeneration. There may be a
period of heavy water usage because of guests or a heavy laundry day.
To initiate a manual regeneration at the preset delayed regeneration time, when
the regeneration time option is set to “NORMAL” or “ on 0”,
press and release “REGEN”. The words “REGEN TODAY” will fl ash on the display to indicate that the system will regenerate at
the preset delayed regeneration time. If you pressed the “REGEN” button in error, pressing the button again will cancel the request.
Note: If the regeneration time option is set to “on 0” there is no set delayed regeneration time so “REGEN TODAY” will not acti-
vate if “REGEN” button is pressed.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for three seconds. The system will begin to
regenerate immediately. The request cannot be cancelled.
Note: For softeners, if the brine tank does not contain salt, fi ll with salt and wait at least two hours before regenerating.
Set Time of Day
The user can also set the time of day. Time of day should only need to be set after power outages lasting more than 24 hours, if the
battery has been depleted and a power outage occurs, or when daylight saving time begins or ends. If a power outage lasting more
than 24 hours occurs, the time of day will fl ash on and off which indicates the time of day should be reset. If a power outage lasts
less than 24 hours and the time of day fl ashes on and off, the time of day should be reset and the battery replaced.
STEP 1U – Press SET CLOCK.
STEP 2U - Current Time (hour): Set the hour of the day using
▼
or
▲
buttons. AM/PM toggles after 12.
Press NEXT to go to step 3U.
STEP 3U - Current Time (minutes): Set the minutes of the day using
▼
or
▲
buttons. Press NEXT to exit
Set Time of Day. Press REGEN to return to previous step.
REGEN TODAY will
Flash if a regeneration is
expected “Tonight.”
➟
STEP 3U
➟
RETURN TO
NORMAL MODE
STEP 2U
➟
STEP 1U
➟